Rochester Carburetor Troubleshooting Guide
Manuals are downloaded as PDF files. Some are very large and might take some time to download, depending on your internet connection. Please do not distribute these manuals. Instead giving out the link to this web page would be appreciated.
Link is as follows: Please keep in mind that these manuals may span several carburetor models and may not be your exact carburetor. Use these manuals as a general reference only. Don't forget to visit the technical pages for your specific carburetor. More manuals for specific carburetors may be available there.
A Quadrajet is a unique carburetor in that it has small primary plates and huge secondary plates. It is a good carburetor for fuel economy and still has stellar performance when required.
In Europe, KIA Sorento 2016 already introduced with a choice of petrol and Diesel engine with four-cylinder also parallel 2400 cc cylinder and a V6 3300 cc KIA Sorento 2016. 2016 kia sorento ex owners manual.
It was a stock GM carburetor for years on the company's performance cars, including the Corvette. It is a good carburetor for up to close to 400 horsepower. Its limit in horsepower applications and ability to be modified was its downfall at the racetrack when horsepower climbed. The Quadrajet uses many moving parts, unlike most carburetors.
Remove the air cleaner. Inspect the choke system while the engine is cold. The choke mechanism is the plate on the top of the carburetor. It has a spring located in the manifold with a rod running up to the plate. There will be a vacuum-operated servo on the passenger side rear of the carburetor, with a rod also attached to the choke mechanism. When the engine is cold, the spring contracts and creates a pull on the choke to close. The throttle keeps it from closing as long as it is not disturbed.
When the engine is started, the throttle should be tapped just a little to allow the choke to snap shut. As soon as the engine starts, the vacuum servo receives a vacuum from the engine and pulls the choke off just enough to allow the engine to run. However, it still creates a partial choke condition. As the engine heats up, the spring in the manifold expands and puts pressure on the choke to open the choke.
Rochester Carburetor Troubleshooting Guide
On all carburetors, the vacuum created as air is moved into the engine sucks the fuel out of the passages in the carburetor. When the engine has just been started, there is obviously no vacuum-so no fuel is sucked into the engine to start. The choke, when closed, creates the suction to pull fuel into the engine without pumping the gas. Pumping the gas a couple times can also start the engine, since the carburetor has an accelerator pump. However, it's easy to flood the engine this way. Move the throttle by hand just a little and see if the choke snaps closed.
Rochester Carburetor Troubleshooting Guide
It should go all the way closed, or the rod is bent or the spring is maladjusted. Start the engine and make sure the choke opens a quarter of the way. If not, pull the hose off the servo and see if the arm extends and contracts when the hose is reinstalled. If not, the servo must be replaced because it operates with a rubber bladder inside and is leaking. This means that not only does it not work, it's leaking vacuum and interfering with the mixture in the carburetor.
This causes the engine to run poorly. If the engine runs OK except at an idle, the idle jets may be out of adjustment of dirty. Using a small screwdriver and starting on the driver's side, adjust the screw in until the RPM starts to drop. Turn the screw out just until the RPM stops rising and turn the screw one half of a turn further. Do the same to the other side and then repeat the process one more time. If the engine idles fine but will not accelerate when the pedal is floored and just falls flat, the accelerator pump is not working and the carburetor has to be overhauled.